- 26 -
Once you’ve validated that the collar triggers a
warning beep, vibration warning, and then
emits a static shock, this means the system is
working properly, and you’re ready to bury or
place the Boundary Wire in its permanent
final position.
VI. Install the Boundary Wire:
Installation of the Boundary wire begins with
burying the wire to protect it and prevent
people, animals, or even weather to disrupt
the wire and break your continuous loop.
To start, cut a trench 1-3 inches deep along
your planned boundary. Place the Boundary
Wire into the trench maintaining some slack
to allow it to expand and contract with
temperature variations. Then use a blunt tool
such as a wooden paint stick to push the
Boundary Wire into the trench; all the while
To Next Page
Loading...