AC•THOR
®
/ AC•THOR
®
9s Operating instructions, version a0020000 4
c. Power meter direct: Connection to my-PV power meter is set up without network
directly by using a crossover network cable.
d. List of possible compatibility partners:
For certain compatible partners the choice between „Auto“ (automatic IP-search of
the device) or „Manual“ (manual entry of the IP address of the source) is possible.
„Manual“ is for instance necessary when there are several compatible sources in the
network and a special one of them should be chosen as the control system.
TIP: On the Web-Interface the selection of compatible
signal sources is much larger than on the display!
e. Further protocols: http, Modbus TCP, Adjustable Modbus TCP
Adjustable Modbus TCP has to be configured in the Web-Interface.
(see chapter „Special setting possibilities in the web interface”)
4. Temperature sensor assignment and activation
A number is assigned to the sensor in the order in which it is selected. The selection can
be deselected by tapping on the key once more.
To assign a sensor to the respective entry in the list, the serial numbers can be identified
on a label attached to the sensor wire.
TIP: As the measuring value of the sensor is already shown in the selection
list, an assignment can alternatively also be made by simply altering the
temperature on the sensor.
5. Save the settings
3. Controls and displays
Homescreen
The "Home" button always returns you to the home screen. The upper bar shows the current date,
time, the unit number und the operating mode (mode M1 – Mx). On the right, symbols show the
unit's current status.
The contents of the home screen vary according to the operating mode and shows how much power
the AC•THOR is currently feeding into the load. Depending on how many, if any, temperature
sensors are defined, the measured values are also shown.
To Next Page
Loading...