18
Feature 09 – Floor Limit Sensor: This function allows you
to set a maximum floor temperature in order to protect
the floor surface from overheating. This function only
applies when the floor sensor is enabled. (see feature 08)
The default setting is 28°C but this can be adjusted from
20 - 45°C.
Feature 10 – Smart Start: The thermostat will automatically
learn the required heat up time and will adjust itself. Smart
Start will bring the heating on early when the weather is cold,
or delays the start up time when the weather is mild so that
the house is warm when you wake up. This means you do
not need to allow any extra heat up time when programming
the comfort levels.
Feature 11 – Rate Of Change: This is the number of minutes
the thermostat has calculated it takes to raise your building
1°C. The thermostat will continue to learn the heat up time of
your home and will adjust this setting to suit (Smart Start).
To Next Page
Loading...
