N-Com B5 User Manual

EN
12
4.3. Pairing up with Bluetooth devices
 Make sure the B5 is turned off;
 Put the system in setting mode: press the “on” key and keep it pressed for 4 seconds, until
the blue LED starts to flash quickly;
 Turn on the search for Bluetooth devices (smartphone, GPS, MP3 reader) on the device;
 Select the N-Com device. If a password is requested, enter 0000 (four zeros);
 Connection between the two devices is established after a few seconds.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when the two
devices are turned off. As a result it needs to be carried out only once.
Automatic Connection
Once the Bluetooth device has been paired up, connection is automatic
when the system is turned on.
Manual Connection
In case connection is not automatically initiated after a few seconds, you
can connect from the Bluetooth device or by pressing “ on ” and keep it
pressed for about 2 seconds.
5. MOBILE PHONE
Answering a phone call
Briefly press any key when you hear the incoming call signal.
Voice call Press “on” and keep it pressed for about 2 seconds.
Redial last number Press “on” and “n” at the same time.
Dial Friend Number Press “n” and keep it pressed for about 2 seconds.
Hanging up/rejecting a
phone call
Press “on” and keep it pressed for about 2 seconds.
Transferring a call from
helmet to mobile phone
To transfer an ongoing call from the helmet to the mobile phone, press
both “on” and “n” at the same time and keep them pressed for 2
seconds.
Manual phone
connection
Press “on” and keep it pressed for about 2 seconds.
Manual phone
disconnection
Press “” and keep it pressed for about 4 seconds.
Conference call function
When a call comes in on a mobile phone connected via Bluetooth to B5, the Rider-Pillion Passenger
intercom is temporarily turned off. However, if you wish to share the phone call with the other helmet,
simply turn on the intercom manually during the phone call.
Turning on the phone conference call function During the phone call, briefly press “n”.
Turning off the phone conference call function During the phone call, briefly press “n”.
N.B.: The Phone Conference Call function can only be used with a Rider-Pillion Passenger intercom
(channel 1) and not with Bike-to-Bike communication (channels 2-6).

N-Com B5 Specifications

General

Brand	N-Com
Model	B5
Category	Automobile Accessories
Language	English