Name: N-Com B5
Brand: N-Com
Rating: 4 (1 reviews)

To Next Page

To Previous Page

3. INSTALLATION

Important: Prior to installing the N-Com system, it is recommended to write down the identification

code affixed to the product (see chapter 16.5).

You can download the installation video from www.n-com.it N-Com / Download section.

 Before you install the B5 system on the helmet, make sure it turns on properly. Press the “on” key

for about 2 seconds, until the LED lights up and you hear a beep in the headset. Proceed with

the installation.

 Remove the cheek padding (see helmet instructions).

 Remove the helmet edge gasket using the special tool (Fig. 1).

 Completely remove the gasket as shown in Fig. 1; by doing so you also remove the padding.

 Remove the “N-Com” plugs found at the back of the shell gasket and on the left side of the

helmet.

Fig. 1

Fig. 1 – ONLY FOR N87 HELMET

 Prior to installing the N-Com system, remove any filling foam material found in the helmet.

Option 1

Option 2

N.B.: Keep the filling material in case you wish to use the helmet without the N-Com system in the

future.

Questions and Answers:

Need help?

Do you have a question about the N-Com B5 and is the answer not in the manual?

N-Com B5 Specifications

General