N-Com B5 - Page 8

EN
8
Fig. 2

Place the system in the special housing in the
back of the helmet, pushing it all the way into
the groove (Fig. 2).

Fold the antenna back inside the shell.
Fig. 3

Fix the cable inside the helmet and make sure
the right fixing clip snaps into its housing (Fig. 3)
Fig. 4

Position the microphone in the housing on the
left of the helmet, inserting the metal boom in
the groove found in the chin guard coupling
frame (Fig. 4).
Caution: make sure that the side of the
microphone support with the writing “N-Com” is
facing inward.
Fig. 5

Fix the cable inside the helmet and make sure
the left fixing clip snaps into its housing.

Hook up the keypad to the helmet by clicking in
the relevant hooks.
NB:
Only for the N87 helmet, follow the instructions
in the paragraph below.

Reassemble the gasket and secure it with the
specific screw.