B5
19
13. SETTING MODE
All Bluetooth pair ups and other adjustments are carried out in this mode.
To put the system in Setting mode (system turned off), press the “on” key and keep it pressed for 4
seconds, until the blue LED starts to flash quickly.
n on
N
+
on
▲
▼
▲
+
▼
Turning on/off the RDS X
Turning on/off the Smart Navi System 2 sec
Pairing up Secondary Phone 2 sec
Pairing up CHANNEL 1 X
Pairing up CHANNEL 2 x2
Pairing up CHANNEL 3 x3
Pairing up CHANNEL 4 X
Pairing up CHANNEL 5 x2
Pairing up CHANNEL 6 x3
Reset 4 sec
*With Friends Configuration active.
14. BATTERY AND RECHARGE
14.1. Low battery signal
During its operation, the system alerts the user with a voice message when the battery is low. From
the first message, the system has a 1-hour autonomy. Warning is given every 10 minute.
14.2. Charging the system
To charge the system, hook it up to the
battery charger or to a USB outlet powered
with the USB-mini USB cable supplied as
standard equipment. The charge will take
place as follows:
B5 system
turned off
When the B5 system is connected to the battery charger, the blue LED starts to flash
quickly. When the battery is charged, the blue LED becomes steady.
B5 system
turned on
When the B5 system is connected to the battery charger, the blue LED starts to flash
quickly. When the battery is charged, the blue LED goes back to its standard flashing.
N.B.: If the device has not been charged for a long time (a few months), it may not be possible to turn
on the system during the first few minutes of the charging, as the voltage may drop below the
minimum limit.
To Next Page
Loading...
Need help?
General
