16
11. BIKE TO BIKE INTERCOM
The N-Com system is used for bike-to-bike communication up to a distance of about 500 m (open
terrain, no obstacles).
The B5 system entails the use of a default “STANDARD” commands configuration, or the use of a
“FRIENDS” configuration that can be turned on from the N-Com Wizard or dedicated App.
The difference between the two configurations lies in the number of motorcycles that can be hooked
up: the STANDARD configurations allows up to 3 different motorcycles to be hooked up to the B5
system, while the FRIENDS configurations allows up to a total of 6.
Important: If you use the FRIENDS configuration, you need to visit the N-Com website and download
the dedicated commands diagram (section Download/Command Summary Diagram).
N.B.: The range and quality of the communication may vary significantly depending on the presence
of obstacles, weather conditions, magnetic fields.
N.B.: The range of the communication varies depending on the N-Com systems used.
11.1. Bike-to-Bike Intercom Affiliation (Standard configuration)
Make sure the B5 is turned off;
Put both systems A and B in Setting Mode (press the “on” key and keep it pressed for 4
seconds, until the blue LED starts to flash quickly);
On system A, press the command related to the “setting position” where you wish to store
system B;
Pairing up CHANNEL 1 Briefly press “n”.
Pairing up CHANNEL 2 Press the “n” key twice.
Pairing up CHANNEL 3 Press the “n” key three times.
Pairing up CHANNEL 4 Briefly press “on”.
Pairing up CHANNEL 5 Press the “on” key twice.
Pairing up CHANNEL Press the “on” key three times.
N.B.: Channels 4-5-6 can be paired up and used only by activating the FRIENDS configuration.
CHANNEL 1 is typically used for the Rider-Pillion Passenger connection, however it can also be used
for the Bike-to-Bike intercom.
The use of CHANNEL 1 is different from the other channels due to the following specific characteristics:
By pressing key "n", the intercom connection is automatically activated.
The Phone Conference function and the GPS Conference function can be used.
To Next Page
Loading...