N-Com bluetoothk it3 User Manual

14
5.1. Affiliation reset function
You can remove all affiliated devices from the system memory. This operation is not
reversible; right after resetting, you will have to repeat the affiliation procedure for
the cell phone (or for other compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
 Press “on” and keep it pressed (for more than 4 seconds), until the LEDs start to
flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up
mode”;
 Press “” and “” at the same time for 4 seconds, and release them when you
hear a beep. The N-Com will emit a special acoustic signal to confirm and will then
turn itself off.
This function can also be turned on through PC using the “N-Com Wizard”
programme.
6. MOBILE PHONE FUNCTIONS
Answering a phone
call
Briefly press any key when you hear the incoming call signal
Hanging
up/rejecting a
phone call
Press “on” and keep it pressed for about 2 seconds (until you
hear the acoustic signal)
Voice call (if
equipped)
Press “on” and keep it pressed for about 4 seconds (until you
hear the acoustic signal)
Redial last number Briefly press “” and “” at the same time
Transferring a call
from helmet to
mobile phone
To transfer an ongoing call from the helmet to the mobile
phone, press both “” and “” at the same time and keep
them pressed for 4 seconds

N-Com bluetoothk it3 Specifications

General

Brand	N-Com
Model	bluetoothk it3
Category	Bicycle Accessories
Language	English