20
Position Button Confirmation beep
A 2 sec. 2 acute beeps
B 2 sec. 2 grave beeps
C 4 sec. 4 acute beeps
D 4 sec. 4 grave beeps
N.B.: If the selected memory setting is taken, you will hear an error beep after which
a different combination must be entered.
4. After a few seconds, the helmets “recognize” one another: a confirmation
beep is given in Helmet 2 that indicates the memory setting where Helmet 1
is stored and Intercom communication is established;
N.B.: if all the memory settings are free, Helmet 2 will store Helmet 1 in position A
(see diagram in Chapter 12.1). In case that setting is taken, the following one will
be selected according to the sequence listed in the table.
You can display the memory settings of your device (and check the names
of the paired up devices) using the “N-Com Wizard” programme for PC.
To make it easier to recognize the N-Com systems paired up in “Bike-to-
Bike” mode, you can rename them using the “N-Com Wizard”.
12.2. Making a Bike-to-Bike call
To make a call to another bike that has been previously paired up, go to the Bike-to-
Bike menu and press the button assigned to the helmet to which you want to make
the call.
The corresponding tone will be heard in your helmet, after which the call to the
selected helmet is made.
N.B.: In case the memory setting is empty, or the other helmet cannot be reached,
an error tone will sound in your helmet.
To Next Page
Loading...
Need help?
General