22
13. INTERCOM VIA CABLE
In order to use N-Com Bluetooth Kit3 as intercom via cable, you need to use an
Intercom Wire (sold separately) to connect the two helmets.
Install the Basic Kit2 + Bluetooth Kit3 in the Rider's helmet.
Fit the Pillion Passenger’s helmet with Basic Kit2 (positioning the basic electronic
card in its housing).
Connect the Rider’s helmet to the Pillion Passenger’s helmet using the Intercom
Wire (sold separately) in the following manner:
- connector A (smaller, L-shaped) in the Rider’s helmet (equipped with Bluetooth kit3)
- connector B (larger one) in the Pillion Passenger's helmet.
To Next Page
Loading...