18 / 24
Charge Method
7. How to Charge
Attached AC adapter performs charge.
(1) Please connect attached AC adapter to a power supply jack, and check lighting of a CHARGE
lamp.
(2) If it becomes -full charge, a CHARGE lamp will change to lighting slightly.
(3) A CHARGE lamp puts out the light by charge end. The maximum charge time is required for
about 5 hours.
Moreover, charge by USB bus power is also possible. Please connect a USB cable with a main part
between PC. However, the software for PC is needed.
Danger
- AC adapter for charge should surely use the thing of main part attachment. If
other AC adapters are diverted, there are a fire not only by failure of a main part
but unusual generation of heat and danger of a burst.
- A main part and AC adapter generate heat during charge. Be careful of handling
enough. Moreover, covering paper and cloth during charge should stop. Please
be sure to charge in a cool place with sufficient ventilation. It may become the
cause of a fire.
- Even if it connects AC adapter for charge, when a CHARGE lamp does not
light up, the defect of a battery pack is considered. Please stop use immediately.
Caution
- Current cannot be measured when it is displayed on a liquid crystal display as
"LOW BATTERY" by drop in voltage of a battery.
Please connect AC adapter immediately and charge a battery.
- If charge is completed, please remove AC adapter.
- After a "LOW BATTERY" display does not charge, and if a battery is exhausted
further, a power source will be turn off automatically.
- A power source may be turn off before displaying "LOW BATTERY" depending
on the state of a battery.
- If it is left where a battery is exhausted, all the saved data will be lost. When
displayed as "LOW BATTERY", or when a power supply is automatically turn off
by consumption, please charge immediately.
To Next Page
Loading...