1 / 24
Outline
1. Outline
This machine is a welding current meter capable of measuring the welding current, welding cycle and
tip voltage of resistance welders and displaying measured values on the liquid crystal display. The
device presents the following features:
1) The equipment is small and lightweight, so that it can be easily carried around within the factory
premises.
2) A large capacity memory allows storage of up to 10000 average data, 20 each cycle / each msec
data and 1 newest waveform data.
3) Data is transmitted to a personal computer and data processing is possible with a personal computer.
(The exclusive software for personal computers is required)
4) Since the charge battery is built in, it is cordless and can be used.
5) Collection of the data in remoteness is possible by radio communications (Bluetooth).
6) The connectors for the cables used are all easy-to-use "one-touch" connectors.
7) There are two measuring ranges, namely, Lo:2.50 to 19.99kA and 10.00 to 49.99kA. You can
select a range best suited to the current levels you are going to measure.
8) The WELD lamp lights up when welding is being detected. Therefore, measuring condition can be
monitored even when you are away from the welding machine.
9) The equipment can be used not only with AC welder but also with DC welder, inverter controlled
welder, and AC inverter controlled welder.
10) Current consumption is minimized by the auto power-off function, in which power is turned off
automatically when there is no key operation, welding.
( [ 10 minutes ], [ 30 minutes ], [ 60 minutes ], and auto-power-off function (OFF))
To Next Page
Loading...