21 / 24
Troubleshooting
Condition Cause Measures
Measurement of the
tip voltage cannot be
erformed.
Is the tip voltage
detection cable
connected?
Please connect the voltage detection
cable between tips.
It is displayed as
" ?.?? V ."
It is the tip voltage overflow error. It
is outside the specification range
(more than 5.00V). Please use it by
specification within the limits.
It is displayed as
" - .- - V ."
It is a measurement impossible
error.
(1) Cycle overflow
(2) current value overflow
(3) current value under flow
(4) cycle setting error
(5) impulse setting error
Has not error generated?
An error should not occur.
It is displayed as
"Memory Error"
Setting data and
measurement data are
destroyed.
Please push any keys.
A LCD display will be the initial
screen "Data Initialize" ->"0.0CY
0.00kA" . A memory is reset
compulsorily. Recovery of a memory
cannot be performed.
It is displayed as
"System Fault:14" or
"System Fault:15" or
"System Fault:16".
The system error has
occurred.
Please contact our company.
To Next Page
Loading...