Need help?Do you have a question about the Nakamichi CR-5A and is the answer not in the manual?
Advises on muting circuit, timer switch, cassette removal, and tape slack.
Details steps for playback, including monitor selection, Dolby NR, and azimuth adjustment.
Covers auto calibration, Dolby NR selection, MPX/Subsonic filters, and input level adjustments.
Guides on adjusting recording levels using peak meters and input controls for optimal sound.
Explains how to select tape length and switch between elapsed, remaining, and 4-digit time modes.
Provides instructions for cleaning heads, capstans, and tape path components.
Advises on muting circuit, timer switch, cassette removal, and tape slack.
Details steps for playback, including monitor selection, Dolby NR, and azimuth adjustment.
Covers auto calibration, Dolby NR selection, MPX/Subsonic filters, and input level adjustments.
Guides on adjusting recording levels using peak meters and input controls for optimal sound.
Explains how to select tape length and switch between elapsed, remaining, and 4-digit time modes.
Provides instructions for cleaning heads, capstans, and tape path components.
General| Type | Cassette Deck |
|---|---|
| Track System | 4-track, 2-channel stereo |
| Tape Type | Type I, II, IV |
| Noise Reduction | Dolby B, C |
| Total Harmonic Distortion | 0.8% |
| Tape Speed | 4.76 cm/s |
| Motor | DC Servo Motor |
| Frequency Response | 20Hz to 20 kHz |
| Signal to Noise Ratio | 70 dB |
| Wow and Flutter | 0.05% |
| Input | Line In |
| Output | Line Out |
| Inputs | Line |
| Outputs | Line |
| Heads | 3 (1 x record, 1 x playback, 1 x erase) |
To Next Page
