A
Maintenance
Cooling circuit - coolant
Draining the cooling circuit
The coolant in the cooling circuit must be drained in order to
remove the various deposits that can build up in the circuit.
• Start the engine and let it run at idle for few minutes.
• Stop the engine, remove the key from the instrument
panel, and let the engine cool to avoid burns.
• Place a pail under the drain cap A and untighten it.
• Let the coolant run out until the exchanger is empty.
• Clean the inside of the heat exchanger by following the
instructions below before closing the cap.
Rinsing the cooling circuit
The cooling circuit must be rinsed after emptying.
• Remove the fi ll cap situated on the top of the heat
exchanger and the drain cap.
• Clean the inside of the heat exchanger with clean water
by placing a hose in the fi ll cap.
• Continue until clean water runs from the drain orifi ce.
• Close the cap then refi ll with coolant.
21
To Next Page
Loading...
Need help?
General
