Technical specifications
NANNI DIESEL ENGINE T4.155 4.380TDI 4.390TDI
Number of cylinders 4 in line
Max. power* 114.1 kW (155 hp) 128.8 kW (175 hp) 147.2 kW (200 hp)
Maximum rated load* 3600 rpm
Idle speed 800/850 rpm
Max no load speed 4100 / 4300 rpm
Cycle 4 strokes
Bore & stroke 96 x 103
Cylinder size 2982 cm3
Compression ratio 19,7
Rotation direction Counter clockwise
Injection order 1-3-4-2
Injection pump DENSO VE 22100-67080
Injection pressure 15.2 MPa
Fuel consumption 280 g/kWh @ 3600 rpm
Timing point before TDC 0.42 +- 0.02 (Plunger stroke)
Dry weight 346 kg 346 kg (ZF45A) 355 kg (ZF45A)
Alternator 12 V - 80A
Battery capacity (min.) 100/110 A/h
Cooling circuit By heat exchanger / Closed cooling system
Sea water pump Neoprene type rotor
Coolant: 50% water + 50 % anti-freeze 15.5 Litres
Valve clearance (cold) Intake 0.25 - Exhaust 0.30
Engine oil recommended API mini CD - SAE 15 W 40
Engine oil capacity, following installation angle 6.4 to 7.7 l
ZF Marine gearbox ZF25A ZF25A 26 / ZF45A
ZF45A
ZF lubricant capacity 1.5 l 1.5-2 l / 2.5 l 2.5 l
Oil specification Automatic transmission fluid, Type A
Technodrive gearbox TM545A TM545A
Oil capacity Technodrive gearbox 2.6 l 2.6 l
Oil specification API mini CD - SAE 15 W 40
Recommended on-board repair kit for motor type T4.155, 4.380TDI, 4.390TDI
DESCRIPTION
Quantity P/N
V-belt Set of 2 970 312 335
Engine oil filter
1 970 312 207
Fuel filter
1 970 312 241
Seawater pump impeller kit
1 970 312 432
Preheating plug
1 970 312 323
Thermostat
1 970 312 274
Thermostat gasket
1 970 312 275
Air intake (O-rings)
2 48 418 164
Air exchanger gasket
4 48 418 168
Injector assembly
1 970 312 310
Injector gasket
1 970 312 309
Water / water exchanger gasket
4 48 418 167
CAUTION: These specifications are designated for pleasure use only.
Recommended cruising speed: 200 rpm below maximum authorised speed.
To Next Page
Loading...
