NanoCam Plus NCP-DVRHD2 - 2.7.8 Contrast; 2.7.9 Exposure; 2.8.0 Auto Record

2.7.8 Contrast
The Contrast setting is used to control the colour contrast of the Car DVR’s photos and videos. To adjust the Contast,
please follow the instructions below.
1. Press the
OK
Button to stop the Car DVR from recording.
2. Hold the
M
Button for 2 seconds to enter the Settings Menu.
3. Use the
<
and
>
Buttons to navigate the Settings Menu and highlight the Contrast setting and press
OK
to select.
4. Use the
<
and
>
Buttons to highlight your required setting, then press the
OK
button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.9 Exposure
Exposure is used to manually control the light sensitivity settings. To change the Exposure setting follow the instructions
below.
1. Press the
OK
Button to stop the Car DVR from recording.
2. Hold the
M
Button for 2 seconds to enter the Settings Menu.
3. Use the
<
and
>
Buttons to navigate the Settings Menu and highlight the Exposure setting and press
OK
to select.
4. Use the
<
and
>
Buttons to highlight your required setting, then press the
OK
button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.8.0 Auto Record
Auto Record setting is used to set whether the DVR starts automatically recording when you turn your vehicle on.
1. Press the
OK
Button to stop the Car DVR from recording.
2. Hold the
M
Button for 2 seconds to enter the Settings Menu.
3. Use the
<
and
>
Buttons to navigate the Settings Menu and highlight the Auto Record setting and press
OK
to
select.
4. Use the
<
and
>
Buttons to turn off and on Auto Record indicated by the check box
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
13