NanoCam Plus NCP-DVRHD2 - 2.8.7 Timezone; 2.8.8 Format; 2.8.9 Default Settings

16
2.8.7 Timezone
The Timezone setting is used to set the time zone that the camera is being used in. To set the time zone please follow the
instructions below.
1. Press the
OK
Button to stop the Car DVR from recording.
2. Hold the
M
Button for 2 seconds to enter the Settings Menu.
3. Use the
<
and
>
Buttons to navigate the Settings Menu and highlight the Timezone setting and press
OK
to select.
4. Use the
<
and
<
Buttons to highlight your required timezone, then press the
OK
button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.8.8 Format
Formatting the Micro SD card will delete all information on the inserted Micro SD Card and prepare the card for use with the
Car DVR.
1. Press the
OK
Button to stop the Car DVR from recording.
2. Hold the
M
Button for 2 seconds to enter the Settings Menu.
3. Use the
<
and
>
Buttons to navigate the Settings Menu and highlight the Format setting and press
OK
to select.
4. Select Confirm and press the
OK
button.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. Formatting your Micro SD Card will delete all files from the card. Once these files have been deleted you will not be able to recover
them.
2.8.9 Default Settings
Default Settings is used to revert the Car DVR's settings to their default settings. To reset the camera to restore the default
settings, please follow the instructions below.
1. Press the
OK
Button to stop the Car DVR from recording.
2. Hold the
M
Button for 2 seconds to enter the Settings Menu.
3. Use the
<
and
>
Buttons to navigate the Settings Menu and highlight the Default Settings setting and press
OK
to
select.
4. Select Confirm and press the
OK
button.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.