Disarming Your System when Returning
1
Enter your premises throu
h the Entry/Exit door. The keypad will sound a steady tone to remind you to
disarm the system before your Entry Delay time expires.
2
Enter your user code. The Red
Armed
li
ht will
o out, indicatin
that the system has been disarmed.
Note: If you make a mistake enterin
your code, press the
key and re-enter the code.
Alarm
Indication
If the Red Armed li
ht is flashin
rapidly, an alarm occurred while you were away.
Proceed with caution!
For your own protection, leave immediately and call authorities from a nei
hbor’s phone .
Silencing an Alarm
In the event that the system
oes into alarm due to a violated bur
lary zone, the bell or siren will sound and
the keypad sounder will also activate. To silence the system, enter your User code. The zone li
ht of the
zone which went into alarm will continue to flash until
is pressed to reset the alarm memory.
Silencing a Fire Alarm
In the event that the Fire alarm activates due to an violated smoke or fire detector, the bell or siren will
sound a distinct pulsatin
tone. The Red
FIRE
li
ht on the keypad will be flashin
, and the keypad sounder
will emit a pulsin
tone. If a Fire Alarm does occur:
1
If a fire is in pro
ress, evacuate the premises immediately!Call the Fire Department from an outside phone.
2
If there is no evidence of a fire, enter your User Code. The bell or siren will silence, and the FIRE li
ht on
the keypad will stop flashin
but will still be lit.
3
Determine which device went into alarm. If you are protected by smoke detectors, the li
ht on the active
detector will be lit. Once it is determined which smoke detector is in alarm, press
to reset the fire zone.
4
If the Fire zone has reset properly, the FIRE li
ht on the keypad should
o out in approx. 30 seconds
If it does not
o out, press
a
ain in a few minutes. If the FIRE li
ht still does not
o out, call for
service.
Disarming Your System / Silencing an Alarm
8
FIRE
AC
SYSTEM
READY
ZONE 3
ZONE 1
ZONE 2
ZONE 5
ZONE 6
ZONE 4
ARMED
Oi218a
page 8
Tuesday, September 16, 1997 08:28
To Next Page
Loading...
Need help?
General
