EasyManua.ls Logo

Napoleon BGD34-1NT User Manual

Napoleon BGD34-1NT
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
W415-0663 / E / 08. 23.12
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.napoleon replaces.com • ask@napoleonproducts.com
1.28C
$10.00
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
WARNING
SAFETY INFORMATION
!
WARNING
- Do not store or use gasoline or other ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use
any phone in your building.
Immediately call your gas supplier from a
neighbours phone. Follow the gas suppliers
instructions.
If you cannot reach your gas supplier, call the
re department.
- Installation and service must be performed by a
quali ed installer, service agency or the supplier.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certi ed kit is used.
If the information in these instructions
are not followed exactly, a re or
explosion may result causing property
damage, personal injury or loss of life.
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
GD34-1NT
BGD34-1NT
NATURAL GAS MODEL
GD34-1PT
BGD34-1PT
PROPANE GAS MODEL
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA 2.22 ANSI Z21.50 FOR VENTED GAS FIREPLACES.
GD34-1 ILLUSTRATED
f i r e - p a r t s . c o m

Table of Contents

Questions and Answers:

Napoleon BGD34-1NT Specifications

General IconGeneral
Fuel TypeNatural Gas
Heat Output34, 000 BTU
BTU34, 000
Ignition TypeElectronic Ignition
Venting TypeDirect Vent

Summary

SAFETY INFORMATION

1.0 INSTALLATION OVERVIEW

2.0 INTRODUCTION

Children and adults should be alerted to the hazards of high surface temperature...

Alerts users to high surface temperatures and advises keeping children supervised to prevent burns.

3.0 VENTING

3.2 TYPICAL VENT INSTALLATION

3.3 SPECIAL VENT INSTALLATIONS

3.4 VENT TERMINAL CLEARANCES

3.5 VENTING APPLICATION FLOW CHART

3.8 HORIZONTAL TERMINATION

(HT) > (VT)

3.9 VERTICAL TERMINATION

4.0 INSTALLATION

RISK OF FIRE, MAINTAIN SPECIFIED AIR SPACE CLEARANCES TO VENT PIPE AND APPLIANCE.

Warns about fire risk and the necessity of maintaining air space clearances around vent pipes and the appliance.

DO NOT FILL THE SPACE BETWEEN THE VENT PIPE AND ENCLOSURE WITH ANY TYPE OF MATERIAL.

Strong warning against filling spaces around vent pipes with any material to prevent fire.

4.1.1 HORIZONTAL INSTALLATION

THE FIRESTOP ASSEMBLY MUST BE INSTALLED WITH THE VENT SHIELD TO THE TOP.

Crucial instruction for correctly installing the firestop assembly with the vent shield positioned upwards.

4.1.2 VERTICAL INSTALLATION

4.2 USING FLEXIBLE VENT COMPONENTS

4.2.2 VERTICAL AIR TERMINAL INSTALLATION

4.2.3 APPLIANCE VENT CONNECTION

4.3 USING RIGID VENT COMPONENTS

RISK OF FIRE, DO NOT ALLOW LOOSE MATERIALS OR INSULATION TO TOUCH THE VENT PIPE.

Warns about fire risk and the danger of insulation touching the vent pipe.

4.3.2 EXTENDED HORIZONTAL AND CORNER TERMINAL INSTALLATION

4.3.3 VERTICAL AIR TERMINAL INSTALLATION

4.4 GAS INSTALLATION

RISK OF FIRE, EXPLOSION OR ASPHYXIATION. ENSURE THERE ARE NO IGNITION SOURCES SUCH AS SPARKS OR OPEN FLAMES.

Critical warning about ignition sources during gas installation to prevent fire or explosion.

4.5 OPTIONAL WALL SWITCH

DO NOT CONNECT EITHER THE WALL SWITCH, THERMOSTAT OR GAS VALVE DIRECTLY TO 110 VOLT ELECTRICITY.

Crucial safety warning against connecting switches or thermostats directly to 110V electricity.

4.6 HARD WIRE INSTALLATION

4.7 VERTICAL THROUGH EXISTING CHIMNEY

RISK OF FIRE! CO-AXIAL TO CO-LINEAR VENTING CONFIGURATIONS MUST ONLY BE USED IN A NON COMBUSTIBLE CHIMNEY OR ENCLOSURE.

Highlights fire risk associated with coaxial-to-colinear venting in non-combustible chimneys only.

4.8 MOBILE HOME INSTALLATION

5.0 FRAMING

DO NOT NOTCH THE FRAMING AROUND THE APPLIANCE STAND-OFFS. FAILURE TO MAINTAIN AIR SPACE CLEARANCE MAY CAUSE OVER HEATING AND FIRE.

Warns against notching framing and stresses maintaining air space to prevent overheating and fire.

Minimum clearance to combustible construction from appliance and vent surfaces:

Details minimum clearances required from combustible materials to appliance and vent surfaces.

5.1.1 MINIMUM FRAMING DIMENSIONS

5.2 BGD34-1 FRAMING

RISK OF FIRE! IN ORDER TO AVOID THE POSSIBILITY OF EXPOSED INSULATION OR VAPOUR BARRIER COMING IN CONTACT WITH THE APPLIANCE BODY...

Warns about fire risk from insulation contact and recommends finishing the appliance enclosure.

MINIMUM CLEARANCE TO COMBUSTIBLES MUST BE MAINTAINED OR A SERIOUS FIRE HAZARD COULD RESULT.

Stresses that maintaining minimum clearances to combustibles is critical to prevent fire hazards.

5.2.1 MINIMUM FRAMING DIMENSIONS

DO NOT BUILD INTO THIS AREA - IT MUST BE LEFT CLEAR TO PROVIDE ADEQUATE CLEARANCE FOR THE VENT.

Warns not to build into a specific area to ensure adequate clearance for the vent.

5.3 MINIMUM CLEARANCE TO COMBUSTIBLE ENCLOSURES

5.5 MINIMUM MANTEL CLEARANCES

RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES...

Warns about fire risk if clearances to combustibles are not maintained, affecting appliance operation and safety.

6.0 FINISHING

RISK OF FIRE! NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.

Warns about fire risk and the critical importance of not obstructing the appliance's front opening.

6.2 LOG PLACEMENT

7.0 OPTIONAL BLOWER INSTALLATION

RISK OF FIRE AND ELECTRICAL SHOCK. TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.

Critical safety warning to turn off gas and electrical power before servicing the appliance.

USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH THIS APPLIANCE.

Reiterates using only approved Wolf Steel accessories and parts for safety and warranty.

8.0 OPERATION

WHAT TO DO IF YOU SMELL GAS:

Lists crucial steps to take if a gas leak is detected.

9.0 ADJUSTMENT

AFTER TAKING PRESSURE READINGS, TIGHTEN SCREWS FIRMLY TO SEAL. DO NOT OVER TORQUE. LEAK TEST.

Instructions to securely tighten screws after pressure readings and perform a leak test.

AIR SHUTTER ADJUSTMENT MUST ONLY BE DONE BY A QUALIFIED INSTALLER!

Emphasizes that air shutter adjustments must be performed only by a qualified installer.

9.4 RESTRICTING VERTICAL VENTS

10.0 MAINTENANCE

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.

Critical safety instruction to turn off gas and electrical power before any servicing.

APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.

Warns that the appliance may be hot and should not be serviced until cooled.

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE ABRASIVE CLEANERS TO CLEAN GLASS.

Crucial warnings against cleaning hot glass or using abrasive cleaners.

10.3 DOOR GLASS REPLACEMENT

DO NOT USE SUBSTITUTE MATERIALS.

Strong warning not to use any substitute materials for door glass replacement.

GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.

Repeats the warning that glass may be hot and should not be touched until cooled.

11.0 REPLACEMENTS

** THIS IS A FAST ACTING THERMOCOUPLE. IT IS AN INTEGRAL SAFETY COMPONENT. REPLACE ONLY WITH A FAST ACTING THERMOCOUPLE SUPPLIED BY WOLF STEEL LTD.

Highlights the fast-acting thermocouple as a critical safety component and specifies using only Wolf Steel replacements.

12.0 TROUBLESHOOTING

13.0 WARRANTY

NAPOLEON® GAS APPLIANCE PRESIDENT’S LIFETIME LIMITED WARRANTY

Outlines the terms of the President's Lifetime Limited Warranty for Napoleon gas appliances.

Related product manuals