J
Jose GreenSep 1, 2025
How do I adjust the pilot flame if it is not large enough on my Napoleon GD40-N?
- FfishermelissaSep 1, 2025
To increase the pilot flame size, simply turn up the pilot flame.
To Next PageTo Next PageHow do I adjust the pilot flame if it is not large enough on my Napoleon GD40-N?
To increase the pilot flame size, simply turn up the pilot flame.
Why is carbon being deposited on the combustion chamber surfaces of my Napoleon GD40-N?
Carbon deposits can occur if the air shutter has become blocked. Ensure the air shutter opening is free of lint or other obstructions.
How to troubleshoot no gas at the pilot burner of my Napoleon GD40-N?
First, ensure that the manual valve is turned on. Next, check the pilot orifice for any blockage. If these steps don't resolve the issue, you may need to replace the valve. As a last resort, call the gas distributor.
What to do if both the main burner and pilot go out on my Napoleon Indoor Fireplace?
If both the main burner and pilot light go out, the issue could be a faulty thermostat or switch. Another possible cause is a blocked vent, so check for any vent blockage.
Why are the flames on my Napoleon GD40-N Indoor Fireplace consistently too large or too small?
This issue can occur if the unit is over-fired or under-fired. Check the pressure readings by turning screw (A) counter-clockwise 2 or 3 turns and then placing pressure gauge tubing over the test point. Carboning can also cause flame issues, so perform a leak test with a soap and water solution.
How to fix a Napoleon GD40-N Indoor Fireplace when the pilot will not light?
If the pilot light won't ignite, first check if there's a spark at the pilot burner; try lighting it with a match. Ensure the wire is connected to the push-button ignitor and that the ignitor is tightened. If the wire insulation is broken or frayed, replace the wire. If the ceramic insulator is cracked or broken, replace the electrode.
Why does the main burner go out but the pilot stays on in my Napoleon Indoor Fireplace?
This can happen if the pilot flame is not large enough or not engulfing the thermopile, so try turning up the pilot flame. Another potential solution is to clean the thermopile connection to the valve and reconnect it. You may also need to replace the pilot assembly or the thermopile/valve.
General| Brand | Napoleon |
|---|---|
| Model | GD40-N |
| Category | Indoor Fireplace |
| Language | English |
