To Next PageTo Next PageWhat to do if my Napoleon Indoor Fireplace pilot flame is not engulfing the thermocouple?
If the pilot flame is not engulfing the thermocouple on your Napoleon Indoor Fireplace, turn up the pilot flame. If that doesn't work, replace the pilot assembly.
What to do if my Napoleon GDI 50 - N Indoor Fireplace has a thermocouple shorting?
If the thermocouple in your Napoleon Indoor Fireplace is shorting, try loosening and tightening it, and clean the thermocouple and valve connection. If the issue persists, replace the thermocouple or the valve.
Why is the flame impinging on the logs in my Napoleon Indoor Fireplace?
If the flame is impinging on the logs or combustion chamber of your Napoleon Indoor Fireplace, check that the logs are correctly positioned. Additionally, you can open the air shutter to increase the primary air. Also, verify the input rate by checking the manifold pressure and orifice size as specified by the rating plate values. Ensure the door gasketing is intact and provides a tight seal. Finally, check that both vent liners are free of holes and well sealed at all joints, and that minimum rise per foot has been adhered to for any horizontal venting.
How to fix carbon deposits on the glass of my Napoleon GDI 50 - N Indoor Fireplace?
If carbon is being deposited on the glass, logs, or combustion chamber surfaces of your Napoleon Indoor Fireplace, the air shutter may be blocked. Ensure the air shutter opening is free of lint or other obstructions.
What to do if my Napoleon GDI 50 - N has exhaust fumes and headaches?
If you smell exhaust fumes in the room or experience headaches when using your Napoleon Indoor Fireplace, check all the seals to ensure they are properly fitted and not damaged.
Why does the pilot light go out on my Napoleon GDI 50 - N Indoor Fireplace?
If the pilot light goes out on your Napoleon Indoor Fireplace, it might be because the system wasn't correctly purged. Purge the gas line with the glass door open to resolve this.
What to do if there's no gas at the pilot burner of my Napoleon Indoor Fireplace?
If there's no gas at the pilot burner of your Napoleon Indoor Fireplace, check that the manual valve is turned on and inspect the pilot orifice for any blockage. If these steps don't resolve the issue, consider replacing the valve. If problems persist, contact the gas distributor.
General| Weight | 145 lbs |
|---|---|
| Vent Type | Direct Vent |
| Burner Material | Stainless Steel |
| Fuel Type | Natural Gas |
| Ignition | Electronic Ignition |
| Dimensions (H x W x D) | 24-1/2" x 36" x 17-3/4" |
Crucial safety instructions, fire prevention, and gas leak emergency protocols.
Outlines the warranty terms, conditions, and limitations for Napoleon gas fireplaces.
Specifies minimum distances from the unit to combustibles, and wall/ceiling protection.
Details vent lengths, air terminal locations, and installation examples for direct vent models.
Instructions for chimney, gas, and vent connections for fireplace inserts.
Covers chimney installation, 'B' vent procedures, adapter, and vent section additions.
Guidelines for horizontal/vertical runs, rise per foot, and air terminal placement.
Specific installation requirements for gas fireplaces in mobile homes.
Procedures for connecting the gas supply, safety checks, and model-specific notes.
Instructions for door operation, trivet, and log placement for aesthetic completion.
How to install the variable speed switch and the fireplace flashing kit.
Guides on operating the unit, spill switch, turbo burner, and routine cleaning.
Step-by-step instructions for lighting the pilot, main burner, and turning off the unit.
Procedures for installing a replacement blower unit for the fireplace.
Details on pilot burner and venturi adjustments for optimal flame performance.
Information on ordering replacement parts, terminal kits, and optional accessories.
Diagnosing and fixing common problems with solutions for pilot, burner, and venting.
A log to record service dates, technician, performed work, and special concerns.
