EasyManua.ls Logo

Napoleon GX70NT - User Manual

Napoleon GX70NT
64 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
EN
FR
PG
65
W415-1519 / C / 11.06.15
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.napoleonfi replaces.com • hearth@napoleonproducts.com
1.28F
$10.00
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
SAFETY INFORMATION
!
WARNING
- Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fi re department.
- Installation and service must be performed by a
qualifi ed installer, service agency or the supplier.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certifi ed kit is used.
If the information in these instructions
are not followed exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
Decorative Product: Not for use as a heating appliance.
BARRIER
SAFETY BARRIER
GX70 ILLUSTRATED
CONFORMS TO AMERICAN NATIONAL STANDARDS: ANSI Z21.50, CERTIFIED TO CANADIAN CSA 2.22 FOR VENTED GAS FIREPLACES.
GX70PT & GX70PTE
PROPANE GAS MODEL
GX70NT & GX70NTE
NATURAL GAS MODEL

Table of Contents

Questions and Answers

  • H
    Heather PatrickAug 14, 2025
    What to do if the pilot sparks but the gas supply won't light on my Napoleon Indoor Fireplace?
    • K
      Kathy GonzalezAug 14, 2025
      If the pilot sparks but the gas supply won't light on your Napoleon Indoor Fireplace, first, make sure the incoming gas line ball valve is open. Then, check that the inlet pressure is within acceptable limits, ensuring it does not exceed 13” W.C. (32.3mb). Also, ensure the air shutter opening is free of any lint or obstructions.
  • B
    Brian LynchAug 17, 2025
    Why won't the pilot light on my Napoleon Indoor Fireplace light?
    • K
      Kenneth FowlerAug 17, 2025
      If the pilot light won't ignite on your Napoleon Indoor Fireplace, check the following: 1. Ensure the sensor and igniter wires are correctly connected to the module. 2. Verify there are no loose connections, electrical shorts, or grounding issues in the wiring. 3. Test the igniter module for spark. Also, inspect the pilot assembly for shorts or cracks. 4. Confirm the igniter spark gap to the pilot is 1/8” (3.2mm). 5. Check the transformer installation, connection to the module, and voltage (6.2-7.0 volts A.C.). 6. If the power is off, check the batteries. 7. Remove and reinstall the wiring harness, checking wire continuity. 8. Troubleshoot with a simple ON/OFF switch. 9. Ensure the valve and pilot assemblies are properly grounded to the metal chassis.
  • H
    herrerachristopherAug 21, 2025
    What to do if my Napoleon Indoor Fireplace sparks and the pilot lights, but the main burner won't light?
    • L
      Lori PhillipsAug 21, 2025
      If your Napoleon Indoor Fireplace continues to spark and the pilot lights, but the main burner won't ignite, check for these potential issues: * Verify all connections to the sensor rod are tight and not grounding out. * Ensure the flame is engulfing the sensor rod and that the correct pilot orifice is installed. * Confirm the wire harness is firmly connected to the module. * Clean the sensor rod with a fine emery cloth or synthetic scrub pad to remove any contamination.
  • J
    juliepetersonAug 25, 2025
    Why is the flame impinging on the glass, logs, or combustion chamber in my Napoleon Indoor Fireplace?
    • J
      jason02Aug 25, 2025
      If the flame is impinging on the glass, logs, rocks, media, or combustion chamber of your Napoleon Indoor Fireplace, make sure that the glass, logs, rocks, or media are correctly positioned. Too much glass media around the burner can cause carbon deposits. Open the air shutter to increase the primary air. Check the input rate (manifold pressure and orifice size) as specified by the rating plate values. Ensure the door gasketing is intact and the seal is tight. Verify that both vent liners are free of holes and well-sealed. Also, ensure that the minimum rise per foot has been adhered to for any horizontal venting.
  • K
    Kristen GutierrezAug 27, 2025
    Why is the main burner flame on my Napoleon Indoor Fireplace blue, lazy, and transparent?
    • A
      amandagriffinAug 27, 2025
      If the main burner flame on your Napoleon Indoor Fireplace is blue, lazy, and transparent, check for a blockage in the vent and remove it. Also, check the venting system parameters, including the seal, length, and rise.
  • J
    Jonathan BowersAug 31, 2025
    Why are the flames so aggressive on my Napoleon Indoor Fireplace?
    • K
      Kevin CarrollAug 31, 2025
      If the flames on your Napoleon Indoor Fireplace are very aggressive, tighten the door clamps if applicable. If the venting action is too great, restrict the vent exit with a restrictor plate.
  • L
    Lindsay HernandezSep 3, 2025
    What to do if I smell exhaust fumes and get headaches when using my Napoleon Indoor Fireplace?
    • C
      Christopher HoodSep 4, 2025
      If you smell exhaust fumes in the room or are experiencing headaches when using your Napoleon Indoor Fireplace, check if the exhaust is re-entering through an open door or window.
  • J
    josephbarnesSep 7, 2025
    Why does a white/grey film form on my Napoleon Indoor Fireplace?
    • R
      Richard StricklandSep 7, 2025
      If a white or grey film forms on your Napoleon Indoor Fireplace, it is likely sulphur from the fuel being deposited on the glass, logs, or combustion chamber surfaces. Clean the glass, but do not clean the glass when it is hot.
  • D
    Diane ThomasSep 10, 2025
    Why does the main burner and pilot light go out on my Napoleon Indoor Fireplace?
    • L
      Lori DavenportSep 10, 2025
      If the main burner and pilot light go out on your Napoleon Indoor Fireplace, vent recirculation may be the cause. Check the joint seals and installation.

Napoleon GX70NT Specifications

General IconGeneral
BrandNapoleon
ModelGX70NT
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals