To Next PageTo Next PageWhat to do if Napoleon Stove won't start?
If your Napoleon Stove won't start, try these steps: add more kindling or paper, ensure the air control is fully open and not obstructed, burn a piece of paper to establish a draft, use dry seasoned wood with 20% moisture content, and inspect the chimney.
Why does my Napoleon Stove glass get dirty?
Dirty glass on your Napoleon Stove can be caused by the air control being closed too far or using improperly seasoned wood. Try burning hotter, smaller fires and use well-seasoned wood with 20% moisture content.
What to do if Napoleon Stove blower does not run?
If the blower on your Napoleon Stove isn't running, the appliance may not be up to temperature. Ensure the blower has power.
Why does my Napoleon Stove smoke when I open the door?
If your Napoleon Stove smokes when the door is opened, it could be due to a cold air blockage or insufficient draft. Try burning a piece of paper to establish a draft, add more pipe, let the air stabilize before opening the door, ensure the baffles are positioned correctly, or open a window near the appliance to address negative pressure.
What to do if Napoleon Stove doesn’t burn hot enough?
If your Napoleon Stove isn’t burning hot enough, it could be because the wood has more than 20% moisture, there's insufficient draft, or not enough air. Make sure the air control is fully open and the air opening isn't obstructed. Adding more pipe might help with draft issues.
Why does wood burn too fast in my Napoleon Stove?
If wood burns too fast in your Napoleon Stove, the air control may need adjustment. Also check if the ash plug is properly seated (if equipped) and inspect the door gasket for an adequate seal. Extremely dry wood can also cause this issue.
General| Remote Control | Optional |
|---|---|
| Fuel Type | Gas |
| Heat Output | 25, 000 BTU/h |
| Log Set | Included |
| Ignition | Electronic Ignition |
