NARDA RadMan - Page 23

21
Operation and use
This alarm state is indicated by a flashing red
LED. The instrument will also emit an audible
BEEP twice a second as an additional
warning signal.
This status is maintained for as long as the
ESM “RadMan” continues to measure this
level of electromagnetic field strength.
100% LED indicates alarm state: 100 % of
the power density (= 100% of the field
strength) permitted by the relevant standard
has been reached.
This alarm state is indicated by a flashing red
LED. The instrument will also emit an audible
BEEP 4 times a second.
This status is maintained for as long as the
ESM “RadMan” continues to measure this
level of electromagnetic field strength.
Tip: The effect of electromagnetic radiation
on the human body is primarily related
to the power density and not the field
strength. For this reason, the display is
calibrated in units of power density.
Tip: By noting the different BEEP repetition
rates, you can easily locate the field
maxima without looking at the LEDs.
Normal operation
Downloaded from Arrow.com.