22
Operation
and use
Automatic recording of measured values
The measured values are automatically
displayed and recorded when the instrument
is switched on. A new block of data is started
each time the instrument is switched on.
Evaluating measurement values
The data blocks can be evaluated singly or
together on a PC with the aid of the ESM-TS
Interface Set, available as an option. All
evaluations can be summarized and saved in
a report.
Configuring the data recorder
The interval between saving consecutive
measurement values can be set within a wide
range using the ESM-TS Interface Set. The
data set saved at the end of the save interval
contains the RMS value, the maximum and
the minimum value from all the H field and the
E field values that were measured during the
save interval (measurement interval 5 ms).
ESM-30 only: Data recorder
Downloaded from Arrow.com.
To Next Page
Loading...
