48
Specifi-
cations
normal batteries. You have at least 30
seconds in which to change the batteries if the
ESM-30 “RadMan XT” is switched on before
replacing the batteries and the self test has
been completed successfully. Otherwise, you
should check the time settings. The date and
time are set using the ESM-TS Interface Set
which is available as an option.
Interfaces
The data from the E-field and H-field probes
can be output separately using the optional
ESM-TS Interface Set.
• The resolution of the data is 0.625% of the
standard limit value in this case.
• 25 measured values are transferred per
second.
ESM-30 only:
The following additional functions are avail-
able:
• Read out values recorded in the data
recorder.
The transfer time for all the data when the
data recorder is completely full is less than
5 minutes.
• Select the save interval:
The time between consecutive saves of
recorded data can be set in several steps
between 1 second and 3 minutes.
• Set date and time.
• Comprehensive evaluation, storage and
exporting of data.
Specifications
Downloaded from Arrow.com.
To Next Page
Loading...
