EasyManuals Logo

National Instruments CompactRIO cRIO-9072 User Manual

National Instruments CompactRIO cRIO-9072
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
IP RESET Switch
Push the IP RESET switch to the ON position and reboot the controller to reset the IP address
and other TCP/IP settings of the controller to the factory defaults. Refer to the Troubleshooting
Network Communication section for more information about resetting the IP address. You also
can push this switch to the ON position to unlock a chassis that was previously locked in
MAX.
NO APP Switch
Push the NO APP switch to the ON position to prevent a LabVIEW RT startup application
from running at startup. If you want to permanently disable a LabVIEW RT application from
running at startup, you must disable it in LabVIEW. To run an application at startup, push the
NO APP switch to the OFF position, create an application using the LabVIEW Application
Builder, and configure the application in LabVIEW to launch at startup. If you already have an
application configured to launch at startup and you push the NO APP switch from ON to OFF,
the startup application is automatically enabled. For more information about automatically
launching VIs at startup and disabling VIs from launching at startup, refer to the LabVIEW
Help.
USER1 Switch
You can define the USER1 switch for your application. To define the purpose of this switch in
your embedded application, use the RT Read Switch VI in your LabVIEW RT embedded VI.
For more information about the RT Read Switch VI, refer to the LabVIEW Help.
NO FPGA Switch
Push the NO FPGA switch to the ON position to prevent a LabVIEW FPGA application from
loading at startup. The NO FPGA switch overrides the CompactRIO reset options described in
the Chassis Reset Options section. After startup you can download to the FPGA from software
regardless of switch position.
Using the RESET Button
Pressing the RESET button resets the processor in the same manner as cycling power.
Note The FPGA continues to run unless you select the Autoload on Any Device
Reset boot option. Refer to the Chassis Reset Options section for more information.
NI cRIO-9072/9073/9074 User Manual and Specifications | © National Instruments | 15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the National Instruments CompactRIO cRIO-9072 and is the answer not in the manual?

National Instruments CompactRIO cRIO-9072 Specifications

General IconGeneral
BrandNational Instruments
ModelCompactRIO cRIO-9072
CategoryController
LanguageEnglish

Related product manuals