National Instruments CompactRIO sbRIO-9603 - Page 23

Figure 17. DIO RESET button
1
1. RESET button
System Reset
Note Resetting the model through the RMC connection implements the same
behavior as using the reset button on the model.
Figure 18. Reset Button Behavior
Press and hold RESET button for ≥ 5 s
Press and hold RESET button for < 5 s
Run Mode
Safe Mode
Press and hold RESET button for < 5 s
Press and hold RESET button for ≥ 5 s
Press and hold
RESET button for ≥ 5 s
Press and hold
RESET button for < 5 s
• Console Out enabled
• Network settings reset
• RT Startup App disabled
• FPGA Startup App disabled
• Console Out enabled
• RT Startup App disabled
• FPGA Startup App disabled
Safe Mode
CompactRIO Single-Board Controller with NI-DAQmx Hardware Installation Manual | © National Instruments | 23