National Instruments CompactRIO sbRIO-9603 - sbRIO-962 x;sbRIO-963 x Mounting and Dimensions

techniques to maintain required connector stack heights and enable improved thermal and
structural design for rugged environments.
sbRIO-962x/sbRIO-963x Dimensions
Figure 28. Primary-Side Dimensions
75T FPGA 81.7 mm (3.22 in.)
200T FPGA 80.1 mm (3.15 in.)
15.0 mm (0.59 in.)
37.0 mm (1.46 in.)
39.5 mm (1.55 in.)
51.7 mm (2.04 in.)
59.2 mm (2.33 in.)
73.3 mm (2.89 in.)
Pin 1
72.8 mm (2.87 in.)
80.8 mm (3.18 in.)
76.7 mm (3.02 in.)
NAND Flash
CPU
46.2 mm (1.82 in.)
38.7 mm (1.53 in.)
USB PHY
24.9 mm (0.98 in.)
ENET 1210
0.0 mm (0.00 in.)
73.2 mm (2.88 in.)
51.8 mm (2.04 in.)
28.4 mm (1.12 in.)
15.4 mm (0.61 in.)
5.4 mm (0.21 in.)
0.0 mm (0.00 in.)
84.6 mm (3.33 in.)
79.4 mm (3.13 in.)
FPGA
65.5 mm (2.58 in.)
55.0 mm (12.16 in.)
43.2 mm (1.70 in.)
NI ASIC 2
8.1 mm (0.32 in.)
24.2 mm (0.95 in.)
DDR Memory
CPLD
NI ASIC 1
75T
200T
Pin 2
OSC
17.1 mm (0.65 in.)
149.9 mm (5.90 in.)
139.1 mm (5.48 in.)
142.4 mm (5.61 in.)
Pin 1
84.5 mm (3.33 in.)
Pin 1
CompactRIO Single-Board Controller with NI-DAQmx Hardware Installation Manual | © National Instruments | 35