National Instruments CompactRIO sbRIO-9603 - Network and Software Setup; Installing Host Computer Software

Table 19. Approximate Power Requirement (Continued)
Power Model Values and Calculations
P
DIO
All sbRIO-96xx
Total DIO current × 3.3 V/0.8
P
5V
All sbRIO-96xx
Total 5 V current × 5 V/0.9
1.5 A, maximum
P
3.3V
All sbRIO-96xx
Total 3.3 V current × 3.3 V/0.8
0.33 A, maximum
Note Actual P
int
will measure between typical and maximum P
int
.
Note Approximate typical P
int
assumes a Real-Time application connected over
Ethernet that loads an FPGA application that blinks the User FPGA1 LED.
Note Approximate maximum P
int
approximates the maximum power requirements
for an NI sbRIO system. Assumptions include 85% LUT, Flip Flop, DSP, BRAM
utilization of the FPGA running at 80 MHz, and 100% processor utilization.
Power-On Self Test
The NI sbRIO-96xx runs a power-on self test (POST) when you apply power to the device.
The Power and Status LEDs turn on when the POST begins. The Status LED turns off when
the POST completes.
Note Refer to the STATUS LED Indicators section to troubleshoot Status LED
behavior.
Installing Software on the Host Computer
Before using the sbRIO-96xx, install the following application software and device drivers on
the host computer.
Application Software
• LabVIEW 2019 SP1 or later
• LabVIEW Real-Time Module 2019 SP1 or later
• LabVIEW FPGA Module 2019 SP1 or later
46 | ni.com | CompactRIO Single-Board Controller with NI-DAQmx Hardware Installation Manual