National Instruments CompactRIO sbRIO-9603 - Page 33

Mounting a sbRIO-960x Model with a Thermal Conduction Path
If possible, NI recommends that you mount the sbRIO-960x on a panel or plate, such that a
thermal solution provides a conduction path from the primary side components and is secured
to or made from the panel or plate.
Figure 26. Thermal Conduction Mounting
10
11
7
9
8
5
6
3
4
1
2
1. Exploded view of all mounting components
2. Complete assembled and mounted view
3. Mounting screws
4. Standoff, 9.65 mm (0.38 in.)
5. Standoff, 16.0 mm (0.63 in.)
6. Thermal Kit for CompactRIO Single Board
Controller with NI-DAQmx (787331-01)
7. RMC board
8. NI sbRIO-9603/9608/9609
9. Thermal pad, main (Included with the Thermal Kit)
10. Thermal pad, supplemental (sbRIO-9603 only)
(Included with the Thermal Kit)
11. Mounting Surface
CompactRIO Single-Board Controller with NI-DAQmx Hardware Installation Manual | © National Instruments | 33