1. Touch the antistatic package to a metal part of the computer chassis.
2. Remove the device from the package and inspect the device for loose components or any
other sign of damage.
Caution Never touch the exposed pins of connectors.
Note Do not install a device if it appears damaged in any way.
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.
Verifying the Kit Contents
Verify that the following items are included in the cRIO-9068 kit.
Figure 1. Kit Contents
1. cRIO-9068 with power connector
2. NI Driver Media
3. Getting Started Guide
Installing Software on the Host Computer
Before using the cRIO-9068, you must install the following application software and device
drivers on the host computer in this order:
1. LabVIEW 2013 or later
2. LabVIEW Real-Time Module 2013 or later
3. LabVIEW FPGA Module 2013 or later
1
4. NI CompactRIO Device Drivers 13.0 or later
For minimum software support information, visit ni.com/info and enter the Info Code
swsupport.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9068, LabVIEW FPGA Module is required.
4 | ni.com | cRIO-9068 Getting Started Guide
To Next Page
Loading...
Need help?
General
