National Instruments cRIO-9068 Getting Started Guide

Installing C Series Modules
Complete the following steps to install a C Series module.
3
2
2
1
1. Verify that power is not connected to the I/O connector(s) on the C Series module. If the
system is in a nonhazardous location, the cRIO-9068 can be powered on when you install
modules.
2. Press the latches on the C Series module.
3. Align the C Series module with a slot and seat it in the slot until the latches lock in place.
Removing C Series Modules
Verify that power is not connected to the I/O connector(s) on the C Series module before you
remove a module from the cRIO-9068. If the system is in a nonhazardous location, the
cRIO-9068 can be powered on when you remove modules.
Connecting the cRIO-9068
The cRIO-9068 has the following connectors, LEDs, and buttons.
cRIO-9068 Getting Started Guide | © National Instruments | 5

National Instruments cRIO-9068 Specifications

General

Brand	National Instruments
Model	cRIO-9068
Category	Chassis
Language	English