National Instruments FieldPoint FP-1000 - Page 52

Chapter 4 Installing and Using the FieldPoint Software
FieldPoint FP-1000/1001 User Manual 4-14
© National Instruments Corporation
4. Select Object
»
Create from the menu bar and choose the FieldPoint
object class from the Drivers category of the Select Object Class
dialog box. The Create FieldPoint Secondary dialog box shown in
Figure 4-6 appears.
Figure 4-6. Creating the FieldPoint Object
5. Create your object.
a. Select the serial port you are using and the data rate (baud rate)
in the Communication Settings area of the dialog box.
b. Enter the path of the configuration file you saved from
FieldPoint Explorer in the IAK Configuration File area, and
make sure the Import alias information box is checked. (You
can use the Browse button to find the configuration file you
saved.)
c. Make any changes you want to make to the poll rate or other
parameters, and click on the OK button.