National Instruments GPIB-USB-HS - Page 19

Chapter 1 GPIB Hardware
GPIB Hardware Guide 1-12 ni.com
5. Insert your PXI card into the selected 5 V slot. Use the injector/ejector
handle to fully inject the device into place. Figure 1-7 shows how to
install your PXI card into a PXI or CompactPCI chassis.
Figure 1-7. Installing Your PXI Card
6. Screw the front panel of the PXI card to the front panel mounting rail
of the PXI or CompactPCI chassis.
7. Power on your PXI or CompactPCI chassis.
The PXI card installation is now complete.
1 Injector/Ejector Handle (In Down Position)
2 Your PXI Card
3 PXI Chassis
4 Injector/Ejector Rail
8
7
6
5
4
3
2
1
ON STANDBY
1
2
3
4