Need help?Do you have a question about the National Instruments GPIB-ENET-1000 and is the answer not in the manual?
General| Interface Type | GPIB and Ethernet |
|---|---|
| GPIB Ports | 1 |
| Ethernet Ports | 1 |
| Ethernet Connector | RJ-45 |
| Operating Temperature | 0 °C to 55 °C |
| Storage Temperature Range | -20 °C to 70 °C |
| GPIB Interface | IEEE 488 |
| Ethernet Interface | 10/100BASE-T |
| Supported Protocols | TCP/IP |
| Maximum GPIB Cable Length | 20 m |
| Power Supply | External |
| Power | 5V DC |
| Relative Humidity Range | 10% to 90% noncondensing |
| Compliance | CE, FCC |
| GPIB Connector | 24-pin IEEE 488 connector |
Steps to connect and install the GPIB-USB interface to a computer.
Explains the status and activity indicated by the LEDs on the GPIB-USB hardware.
Technical specifications for GPIB-USB-HS, including performance and physical characteristics.
Instructions for installing PCIe and PCI GPIB boards into computer expansion slots.
Performance and physical characteristics for PCIe and PCI GPIB variants.
Steps to install the ExpressCard-GPIB interface into a computer.
Performance, power, and physical characteristics for the ExpressCard-GPIB.
Procedure for installing the PMC-GPIB board into a system.
Performance, power, and physical characteristics for the PMC-GPIB.
Guide for installing PXI GPIB cards into PXI or CompactPCI chassis.
Performance and physical characteristics for PXI and PCI 8232 interfaces.
Steps to connect and set up the GPIB-ENET/1000 Ethernet interface.
Information found on the device label, including serial number and MAC address.
Details on setting up network parameters, DHCP, Auto IP, and static IP.
Information on firmware updates and error signaling via READY LED.
Important safety guidelines for operating and handling GPIB controllers.
Standards met for electromagnetic compatibility for measurement and control equipment.
To Next Page