Appendix A Menus and Commands
© National Instruments Corporation A-11 NI Ultiboard User Manual
Place»Follow-me
Use to place a trace between two selected points. Refer to the Placing a
Trace: Follow-me Method section of Chapter 5, Working with Traces and
Copper, for more information.
Place»Connection Machine
Use to place a trace between two pads. Refer to the Placing a Trace:
Connection Machine Method section of Chapter 5, Working with Traces
and Copper, for more information.
Place»Shape
Use to place shapes of different types:
• Ellipse—Use to place an ellipse.
• Rounded Rectangle—Use to place a rounded rectangle.
• Circle—Use to place a circle.
• Pie—Use to place a pie shape.
• Rectangle—Use to place a rectangle.
• Polygon—Use to place a polygon.
Refer to the Placing Shapes and Graphics section of Chapter 4, Working
with Parts, for more information.
Place»Dimension
Use to place different dimension types:
• Standard—Use to place a standard dimension (a dimension to be
placed at an angle).
• Horizontal—Use to place a horizontal dimension.
• Vertical—Use to place a vertical dimension.
Refer to the Placing Dimensions of Chapter 4, Working with Parts, for
more information.
Place»Graphic»Line
Use to place a line or a trace, depending on the active layer. Refer to the
Placing Shapes and Graphics section of Chapter 4, Working with Parts,
and the Placing a Trace: Manual Method section of Chapter 5, Working
with Traces and Copper, for more information.
To Next Page
Loading...
