Chapter 1 User Interface
NI Ultiboard User Manual 1-44 ni.com
Spreadsheet View: Keep-ins/Keep-outs Tab
Use the Keep-ins/Keep-outs tab to work with information for Keep-in or
Keep-out areas.
Column Description
Name Name of the Keep-in or Keep-out. Can be entered
here, or in the Keep-in/Keep-out Properties dialog
box. Refer to the Working with Keep-in/Keep-out
Areas section of Chapter 5, Working with Traces and
Copper, for more information.
Type Indicates whether the area is a Keep-in or a Keep-out.
Can be set here or in the Keep-in/Keep-out
Properties dialog box. Refer to the Working with
Keep-in/Keep-out Areas section of Chapter 5,
Working with Traces and Copper, for more
information.
Locked Yes means that the Keep-in/out area cannot be moved
or edited. No means that the Keep-in/out area can be
moved.
Layers To
Apply
Double-click to display the Layers To Apply dialog
box, where you select the layers to which you wish to
apply the Keep-in/out. You can also set this in the
Keep-in/Keep-out Properties dialog box. Refer to
the Working with Keep-in/Keep-out Areas section of
Chapter 5, Working with Traces and Copper, for more
information.
Net Group Double-click to display the Select Groups dialog
box, where you select the net group to which you wish
to apply the Keep-in/out. You can also set this in the
Keep-in/Keep-out Properties dialog box. Refer to
the Working with Keep-in/Keep-out Areas section of
Chapter 5, Working with Traces and Copper, for more
information.
To Next Page
Loading...
