NET "aAoMxpSpiMosi_n" OFFSET = OUT 20 ns AFTER "Clk40";
#Accelerometer I2c Timing
NET "aAccelSda" OFFSET = IN 5 ns VALID 10 ns BEFORE "Clk40";
NET "aAccelScl" OFFSET = OUT 20 ns AFTER "Clk40"; #Accelerometer I2c Parameter
NET "aAccelSda" OFFSET = OUT 20 ns AFTER "Clk40"; #Accelerometer I2c Parameter
##################################################################################
##################################################################################
Special Pinnout instructions:
1) In your FPGA drive aDriveLow0, aDriveLow1, and aDriveLow3 to a '0'. These are used to control
some proprietary circuitry. If these are not driven low then the analog input's input impedance will be
different than specified in the myRIO user manual.
2) Configure RESERVED pins as inputs. DO NOT DRIVE THESE PINS YOU MAY DAMAGE YOUR BOARD
PERMENANTLY.
To Previous Page
Loading...
Need help?
General
