M Series User Manual
© National Instruments | I-5
timing diagrams, B-31
counter input delays, B-31
timing signals, 7-24
triggering, 7-29
troubleshooting, C-3
counting edges, 7-2
crosstalk when sampling multiple
channels, C-1
custom cabling, 2-7
D
DACs, 5-1
DAQ
hardware, 2-1
system, 2-1
DAQ-6202, 2-2
DAQ-STC2, 2-2
data
acquisition methods, 4-9
generation methods, 5-3
transfer methods, 10-1, 10-2
DMA, 10-1
IRQ, 10-2
programmed I/O, 10-2, 10-3
USB Signal Stream, 10-2
default
counter terminals, 7-28
NI-DAQmx counter/timer pins, 7-28
pins, 7-28
detection, troubleshooting, C-3
device
information, A-1
multiple synchronization, 9-3
NI 6220, A-2
NI 6221, A-4
NI 6224, A-13
NI 6225, A-15
NI 6229, A-21
NI 6250, A-27
NI 6251, A-29
NI 6254, A-37
NI 6255, A-39
NI 6259, A-45
NI 6280, A-53
NI 6281, A-55
NI 6284, A-61
NI 6289, A-63
pinouts, 1-13
self-calibration, 1-4
specifications, A-1
DI change detection, 6-7
DI Sample Clock signal, 6-3
di/SampleClock, 6-3
DIFF connections
using with floating signal sources, 4-13
using with ground-referenced signal
sources, 4-19
when to use with floating signal
sources, 4-12
when to use with ground-referenced
signal sources, 4-18
differential analog input, troubleshooting, C-1
differential connections
using with floating signal sources, 4-13
using with ground-referenced signal
sources, 4-19
when to use with floating signal
sources, 4-12
when to use with ground-referenced
signal sources, 4-18
digital
waveform acquisition, 6-3
waveform generation, 6-4
digital I/O, 6-1
block diagram, 6-1
circuitry, 6-1
connecting signals, 6-8
DI change detection, 6-7
digital waveform generation, 6-4
getting started with applications in
software, 6-9
I/O protection, 6-5
programmable power-up states, 6-6
static DIO, 6-2
timing diagrams, B-28
triggering, 11-1
waveform acquisition, 6-3
waveform triggering, 6-2
digital routing, 9-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
