Inserting and Removing the NI-XNET
Transceiver Cable
The NI-XNET Transceiver Cable connects to a host device with
an active latching connector. To connect the NI-XNET
Transceiver Cable to a host device, push the connector assembly
into the host receptacle until the internal latch snaps into position.
The latch emits an audible click when engaged. To remove the
NI-XNET Transceiver Cable, push the lock ejector forward to
disengage the latch and simultaneously pull the NI-XNET
Transceiver Cable, as shown in the following figure.
NI 9860 Getting Started Guide | © National Instruments | 9
To Next Page
Loading...
