© National Instruments | A-1
A
cDAQ-9191 Regulatory
Information
United States
This product generates and radiates radio frequency energy. To comply with the radio frequency
radiation exposure guidelines in an uncontrolled environment, this equipment must be installed
and operated while maintaining a minimum body-to-antenna distance of 20 cm.
This product complies with Part 15 of the FCC Rules. Operation is subject to these
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This product does not contain any user serviceable components. Any unauthorized product
changes or modifications will invalidate the warranty and all applicable regulatory certifications
and approvals.
Canada, Industry Canada (IC) Notices
This product complies with Industry Canada RSS-210.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
Under Industry Canada regulations, the radio transmitter(s) in this device may only operate
using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Radio Frequency (RF) Exposure Information
The radiated output power of this device is below the Industry Canada (IC) radio frequency
exposure limits. This device has been evaluated for and shown compliant with the IC Radio
Frequency (RF) Exposure limits. The device should be used in such a manner such that the
potential for human contact during normal operation is minimized.
To Next Page
Loading...
Need help?
General
