National Instruments NI CompactDAQ 9184 User Manual

1-30 | ni.com
Chapter 1 Getting Started with the cDAQ Chassis
Reset Button
The cDAQ chassis is equipped with a reset button.
Pressing the reset button results in the following chassis responses:
• When pressed for less than five seconds, the chassis reboots with the current configuration.
• When pressed for five seconds or longer, the STATUS LED lights. When released, the
chassis reboots into factory default mode, which returns the chassis user configuration to
the factory-set defaults listed in Table 1-7.
Power Connector
Refer to the specifications document for your cDAQ chassis for information about the power
connector on the cDAQ chassis.
PFI BNC Connectors
(cDAQ-9188) Refer to the PFI section of Chapter 4, Digital Input/Output and PFI, for
information about the BNC connectors for PFI 0 and PFI 1.
Antenna
(cDAQ-9191) Refer to the NI cDAQ-9191 Specifications for information about the antenna on
the cDAQ-9191 chassis.
Table 1-7. cDAQ Chassis Default Settings
Attribute Value
Hostname cDAQ91xx-<serial number>
IP DHCP or Link Local
Comment Empty
NI Auth User name = admin
Password = no password required

National Instruments NI CompactDAQ 9184 Specifications

General

Brand	National Instruments
Model	NI CompactDAQ 9184
Category	Chassis
Language	English