1-8 | ni.com
Chapter 1 Getting Started with the cDAQ Chassis
Caution When operating the cDAQ-9181/9184/9188/9191 in hazardous locations,
you must use the power connector with a power supply rated for hazardous locations.
The power supply included in the cDAQ-9181/9184/9188/9191 kit is not hazardous
locations-certified. Visit
ni.com to find hazardous locations-certified power
supplies.
The POWER and STATUS LEDs light. The POWER LED lights as long as power is being
supplied to the cDAQ chassis. The STATUS LED turns off after firmware boots. Refer to
the LEDs section for information about the LEDs on the cDAQ chassis.
15. (cDAQ-9191) If you want to connect the cDAQ-9191 to a wireless network, complete the
following steps:
a. Double-click the NI MAX icon, on the desktop to open Measurement & Automation
Explorer (MAX). Expand Devices and Interfaces»Network Devices.
b. Select the chassis and click the Network Settings tab. If your chassis is not listed,
refer to the Finding a Network DAQ Device in MAX topic in the Measurement &
Automation Explorer Help for NI-DAQmx.
c. Select your country.
To Next Page
Loading...
Need help?
General
