National Instruments PCI-6035E Programmer's Manual

Chapter 4 Programming
PCI E Series RLPM 4-22
© National Instruments Corporation
AI_START_STOP_Select_Register = 0x0062;
Joint_Reset_Register
AI configuration start = 0;
AI configuration end = 1;
7. Perform Analog Input Example 1 Step 11.
8.
Convert_Signal selects the convert signal for the acquisition.
Joint_Reset_Register
AI configuration start = 1;
AI_Mode_3_Register
AI SI2 source = 1;
AI_SI2_Load_A_Register
AI SI2 special ticks -1 = 1999;
AI_SI2_Load_B_Register
AI SI2 ordinary ticks -1 = 1999;
AI_Mode_2_Register
AI SI2 reload mode = 1;
AI_Command_1_Register
AI SI2 load = 1;
AI_Mode_2_Register
AI SI2 initial load source = 1;
Joint_Reset_Register
AI configuration start = 0;
AI configuration end = 1;
9. Perform Analog Input Example 1 Step 4.
10. Call
AI_Arming to arm the analog input counter.
AI_Command_1_Register
AI SC arm = 1;
AI SI arm = 0;
AI SI2 arm = 1;
AI DIV arm = 1;
11. Poll the AI FIFO not empty flag in the AI_Status_1_Register until not
empty and read the ADC FIFO data in the ADC_FIFO_Data_Register.
Do
{
If (AI FIFO not empty) then
read FIFO data;
} while (20 samples have not been read)

National Instruments PCI-6035E Specifications

General

Brand	National Instruments
Model	PCI-6035E
Category	Computer Hardware
Language	English