Chapter 1 Introduction
NI 660x User Manual 1-2 ni.com
The specification permits vendors to develop sub-buses that coexist with
the basic PCI interface on the bus. Compatible operation is not guaranteed
between devices with different sub-buses nor between devices with
sub-buses and PXI. The standard implementation for does not include
these sub-buses. The PXI TIO Series device works in any standard chassis
adhering to the PICMG 2.0 R3.0 core specification.
PXI-specific features are implemented on the J2 connector of the bus. The
PXI device is compatible with any chassis with a sub-bus that does not
drive the lines used by that device. Even if the sub-bus is capable of driving
these lines, the PXI device is still compatible as long as those pins on the
sub-bus are disabled by default and never enabled.
Caution Damage can result if these lines are driven by the sub-bus. NI is not liable for any
damage resulting from improper signal connections.
Getting Started
Before installing your DAQ device, you must install the software you plan
to use with the device.
Installing NI-DAQ 7.x
If you are using NI-DAQ 7.1 or later, refer to the DAQ Getting
Started Guide, which you can download at
ni.com/manuals.
The DAQ Getting Started Guide offers NI-DAQ users step-by-step
instructions for installing software and hardware, configuring channels
and tasks, and getting started developing an application.
Installing Other Software
If you are using other software, refer to the installation instructions that
accompany your software.
Installing the Hardware
The DAQ Getting Started Guide contains non-software-specific
information about how to install PCI, PXI, PCMCIA, and USB/IEEE 1394
devices, as well as accessories and cables.
To Next Page
Loading...
Need help?
General
