National Instruments PCI-8361 User Manual

MXI-Express x1 Series User Manual
© National Instruments Corporation | 2-5
Table 2-2. MXI-Express x1 Daisy-Chain Connectivity Support From a Chassis Using a Copper Cable
From Chassis Targets
PXI Chassis
VXI
Chassis PXI Express Chassis MXI-Express RIO
Slot Type Product
PXI-
8360
PXI-
8368
PXI-
1033
*
VXI-
8360T
PXIe-
8360
PXIe- 1073
*
NI 9157
*
NI 9159
*
PXI or PXIe Hybrid
PXI-8364  — —
†
—
†
—
†
—
†

**

**
PXI-8367 —  — — — — — —
PXI Express or PXIe Hybrid
PXIe-8364  —      
ExpressCard
‡
ExpressCard-8360  —      
*
Product has an integrated MXI-Express x1 port.
†
These configurations are not supported, even though the front panel MXI connectors are mechanically compatible. For these configurations the boards
will likely report a valid cable link via the front panels LEDs. Since these link scenarios expose a possible data integrity issue that may not be obvious to the user, National Instruments strongly recommends against using these configurations.
**
Daisy-chaining from PXI Express or ExpressCard slots will give better throughput and latency performance than PXI or PXI Express hybrid slots.
‡
ExpressCard slot of an embedded controller that is installed in the chassis to be daisy-chained from.
Note: For installation instructions and other information concerning the PXI-1033, PXIe-1073, VXI-8360T, NI 9157, and NI 9159 refer to their respective user manuals. Note: For full PXI or PXI Express functionality, refer to the Software Installation and Configuration section of Chapter 3, Installation and Configuration, for more information.

National Instruments PCI-8361 Specifications

General

Brand	National Instruments
Model	PCI-8361
Category	PCI Card
Language	English