A-16 | ni.com
Appendix A Specifications
Notice For EMC declarations and certifications, and additional information, refer
to the Product Certifications and Declarations section.
Notice Changes or modifications to the product not expressly approved by NI
could void your authority to operate the product under your local regulatory rules.
Notice The performance of this product can be disrupted if subjected to
Electrostatic Discharge (ESD) during operation. To prevent damage,
industry-standard ESD prevention measures must be employed during installation,
maintenance, and operation.
Notice This product may become more sensitive to electromagnetic disturbances
in the operational environment when test leads are attached or when the product is
connected to a test object.
Notice Operate this product only with shielded cables and accessories.
Notice The length of all I/O cables must be no longer than 7 m (23 ft).
EMC Standards
This product meets the requirements of the following EMC standards for electrical equipment
for measurement, control, and laboratory use:
• EN 61326-1 (IEC 61326-1): Class A emissions; Basic immunity
• EN 55011 (CISPR 11): Group 1, Class A emissions
• AS/NZS CISPR 11: Group 1, Class A emissions
• ICES-001: Class A emissions
Note Group 1 equipment is any industrial, scientific, or medical equipment that
does not intentionally generate radio frequency energy for the treatment of material
or inspection/analysis purposes.
Note In Europe, Australia, New Zealand, and Canada (per CISPR 11) Class A
equipment is intended for use in non-residential locations.
Caution This equipment is not intended for use in residential environments and
may not provide adequate protection to radio reception in such environments.
Attention Cet équipement n'est pas destiné à être utilisé dans des environnements
résidentiels et peut ne pas fournir une protection adéquate à la réception radio dans
de tels environnements.
To Next Page
Loading...
